Fein WSG7-115 Mode D'emploi page 19

OBJ_BUCH-0000000194-003.book Page 19 Friday, December 11, 2015 12:00 PM
Dry grinding (figure 8).
Observe a lead angle of 20 – 40°. This will
ensure a good removal rate.
Apply uniform pressure with the power
tool and move it over the surface.
Avoid excessive heating of the work-
piece surface.
Cutting (figure 9).
Always work in an up-grinding motion,
so that the cutting disc will not jump out
of the cut.
Fig. 8
Fig. 9
en
19