Mountings; Connection - Elnur Gabarron PG4Z Mode D'emploi

Mountings

Switch off the mains power
before handling the device.
• Lift off the cover by using
a screwdriver.
• Separate the programmer
from its base by loosening
the clamp screw ➊
(vis imperdable).
1
• Secure the base with
3 screws and pegs or on
a flush mounted box
(distance between centres
60 mm).
Note: the base must be secured using 3 screws.
Note: To protect the power supply to the PLC
programmer, you must use a 10 A circuit breaker at
least (do not use a 2 A circuit breaker).
- 32 -

Connection

• Connect the two power
leads to the terminal
1
Partitions (➋) that can be
removed by pliers are provided
for passing the connection
wires if required.
• Fit the programmer onto
the tab of the base and secure
it with the clamp screw ➊.
• Place the cover back on
the programmer
• The programmer is ready to be
used.
2
- 33 -