Power Line Carrier Principle - Elnur Gabarron PG4Z Mode D'emploi

Power line carrier principle

Power line carrier transmission
The principle of "PLC" transmissions is to stack an enco-
ded signal with a higher frequency and weaker amplitude
on the signal present between the live and neutral wires
(230 V, 50 Hz).
The programmer can
be used in blue tariff
Transmitter
installations with an
area less than 180 m 2 .
The DELTA DORE X2D
protocol conforms to the
NF-EN50065-1 standard which allows several PLC
systems that comply with the standard to coexist in
one installation.
Advantages:
- No damage to the existing installation – Upgradeability
of the system
- Diversity of receivers
- No filter necessary at the head of electric installation.
- Standard UTE NF C15-100 and good practice must be complied
with.
- Connected or nearby equipment must not generate excessive
interference (directive 2004/108/CE).
50 Hz
Carrier
Receiver
frequency
Mains network
230V
- 30 -
The X2D PLC receiver
The quality of the comfort temperature
control depends on the quality of
the convector thermostat.
Energy
manager
(option)
remote-info
1 DHW output
N L
N N L L
electric
water heater
N
L
PLC PLC
receiver receiver
Convectors zone 1
Phase coupler
In three-phase installations,
you must use a phase coupler
to transmit on the 3 phases
simultaneously (ref. 6051046)
N Ph1 Ph2 Ph3
Telephone Remote Control
TYPHONE 2 CPL
(optional)
Mains power
supply
230 V - 50Hz
PLC
receiver
Convectors zone 2 Convectors zone 3
- 31 -