Time Setting - Elnur Gabarron PG4Z Mode D'emploi

Associating receiver B to load
shedding channel 3.
Sur l'émetteur :
Press + or -- to select the load
shedding channel: d=3.
On the receiver:
Press the button for
5 seconds until the OK LED
begins flashing slowly.
Press and release button
The green LED stops flashing.
Receiver B is associated with zone 1 and load
shedding channel d=3.
Note:
You can go straight to the receivers'
association menu at any time.
To do so:
5 sec.
➊ Turn the knob to shutdown
2
➋ Press the second button for
5 seconds.
1
Selecting
the load-shedding
.
- 40 -
To remove receiver associations (reset the receivers).
• Press button on the receiver for 1 minute.
The "TH" LED flashes and the association with
the transmitter is removed.
CF06 - Installation fault display
Installation fault
display
Turn the knob to exit the maintenance mode.

Time setting

Turn the knob to .
The days begin to flash.
Press + or -- to make your choice,
OK to confirm it and go to
the next setting.
Perform the same procedure to
set the hours and minutes. Turn the knob to exit
the setting mode.
Communication fault with
the energy manager
Communication fault with
the electronic counter
Communication fault with
the Typhone 2 PLC
Hours
Minutes
- 41 -
Day