Elnur Gabarron PG4Z Mode D'emploi page 20

Associating receivers (CF05)
For each receiver, you must specify the programming
zone with which it is to be associated as well as its load
shedding channel (from d1 to d8, d0 = no load shedding).
If more than one receiver is associated with the same
programming zone, it is recommended that they each
be given a separate load shedding channel to prevent
simultaneous load shedding.
On the transmitter:
select the zone to associate by pressing the
then press + or -- to choose the load shedding channel,
e.g. d=2
Selecting Selection of
the load-shedding programming
channel zone
(only if associated
Go to menu
with an energy
CF06
manager)
button,
The transmitter sends
a frame to the receivers.
- 38 -
On the receiver: Press the
until the receiver's OK LED begins to flash slowly.
Press and release the
The LED stops flashing.
The receiver is now associated with the selected zone.
Repeat the procedure for each zone. Press OK to exit
the association mode.
Example: Receivers A and B are associated
with zone 1.
Receiver A: load shedding channel
2 Receiver B: load shedding channel 3
Associating receiver A
to the load shedding channel 2.
On the transmitter:
Press + or -- to select the load
shedding channel: d=2
On the receiver:
Press the button for 5 seconds
until the receptor's OK LED
begins to flash slowly.
Press and release button
flashing. Receiver A is associated with zone 1 and load
shedding channel d=2.
button for 5 seconds
button.
Load-shedding
channel selection
. The green LED stops
- 39 -
Go to
the CF06
menu