Troubleshooting; Environmental Protection; Available Accessories - Jet Tools JWBS-10 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

With a 13mm wrench, loosen socket head screw on back of
cabinet that secures the motor.
Push motor down to add tension to belt.
The belt is properly tensioned when moderate finger
pressure on the belt between the two pulleys causes a 1/2"
deflection.
Tighten socket head screw that secures motor.
9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*dust on wheel-
clean tires.
*sawblade has cracks-
replace sawblade immediately
Cut is not square
*Table stop setting wrong.
*Blade guide setting is bad
Cutting surfaces is bad
*Wrong sawblade used
*resin collection on sawblade
*sawblade is dull
*Blade guide setting is bad
*Blade tension too low
*workpiece inhomogeneous
*Feed pressure too high-
Do not force the workpiece.

10. Environmental protection

Protect the environment.
Your appliance contains valuable materials which can be
recovered or recycled. Please leave it at a specialized
institution.

11. Available accessories

Refer to the JET-Price-list

Publicité

Table des Matières
loading

Table des Matières