Publicité
Les langues disponibles
Les langues disponibles
HPT 300 • HPT 300C
2.4 Steps before installation, selection of installation location
Before starting any installation step, please, ensure that the planned location of the
water heater installation fulfils the following requirements:
a) It should be installed in a room of more than 8 m² floorspace. Do not place the
appliance in a room exposed to the formation of ice. Do not place the appliance
in a room where another appliance works that requires air for its operation (i.e.
gas furnace, water heater operated by gas, etc.) It is forbidden to operate the hot
water tank outdoors or in a place exposed to rain or moisture.
b) In order to ensure adequate operation of the appliance and to facilitate its
maintenance, the selected location has to allow suitable safety distances
measured from the walls and the ceiling (Figures 2.4.-1 and 2.4.-2.) Make sure that
the floor is flat and stable enough.
c) Leg fixing: Secure the 3 foot mounts supplied with the device with a minimum M8
screw with a push-in metal dowel (M8x75) drilled into the base. The position of the
footrest is as shown in Figures 2.4-3. Adjust the adjustable feet of the unit to a mi-
nimum of 26 mm. (see Figures 2.4-4)
Carefully push the appliance in the direction of the leg fasteners already screwed
down, so that the adjustable legs hit the end of the open groove in the feet
fasteners (Figure 2.4.-5.). If the appliance is operated without leg fastener, it may
tip over. In this case, the manufacturer assumes no liability for possible damages.
60
2.3. Overall dimensions and names
Figure 2.3.-1
Publicité
