Appendix A: Trouble Shooting; A.1.1 Ups - Atlantis Land OnePower A03-S1001 Manuel

APPENDIX A: TROUBLE SHOOTING

If the UPS is not functioning properly, you can refer first to this chapter for simple
troubleshooting before contacting your reseller. This could save you time and
effort but if the problem persist, then consult your service provider.

A.1.1 UPS

The LED and the acoustic signals are a profit tool to individualize immediately
possible problems
Situation
Mains normal but
Line ( ) LED is
not on.
Inverter ( ) LED
flashes every
seconds but no
output.
Alarm buzzer
beeps
continuously
when Utility
normal.
Alarm buzzer
beeps for
seconds, then the
UPS is turned off.
No LEDs display
on the front panel
UPS does
provide expected
backup time.
The UPS operates
normally, but the
Check Items
1. Is the power switch on?
2. Check the Fuse?
3. Is the power cord loose?
1. Battery voltage is too low.
2
1. Check the load status
is
10
1. The UPS's battery is weak
not
due to recent outage.
2. The UPS's battery is near
the end of its service life.
1. Building wiring error such
as missing ground or hot to
A03-S1001/A03-S1501
OnePower Line Interactive UPS (EN)
1. Press Main Switch on.
2. Change fuse with same
3. Re-connect the power cord
1. Recharge the UPS for 24
1. Remove
1.
1.
1. Charge the battery.
2. If the battery is near the end
1. Call a qualified electrician in
Solution
rating.
properly.
hours.
some
load.
Remove some
load and re-switch on the
UPS.
Contact Atlantis Land.
of its service life, you have
to replace the battery.
order to correct the building
uncritical
uncritical
Pag. 25