Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
APPENDIX A: TROUBLE SHOOTING
If the UPS is not functioning properly, you can refer first to this chapter for simple
troubleshooting before contacting your reseller. This could save you time and
effort but if the problem persist, then consult your service provider.
A.1.1 UPS
The LED and the acoustic signals are a profit tool to individualize immediately
possible problems
Situation
1. Is the power switch on?
Mains normal but
2. Check the Fuse?
Line (
) LED is
3. Is the power cord loose?
not on.
1. Battery voltage is too low.
Green LED (
)
keeps
flashing
and alarm buzzer
beeps once every
0.5 second).
1.Check loading status if it is
UPS
turns
off
in overload.
shortly
when
2.Check
Utility Failure.
defective or not.
UPS is unable to
. Check to see if the Main
1
Switch
turn ON/OFF.
longer than 3 seconds or not.
No LEDs display
on the front panel
1. The UPS's battery is weak
UPS
does
not
due to recent outage.
provide expected
2. The UPS's battery is near
backup time.
the end of its service life.
1. Is the Utility Normal?
UPS
switch
on
then
connect
OnePower UPS 600VA/300W(EN)
Check Items
1. Press Main Switch on.
2. Change fuse with same
3. Re-connect the power cord
1. Recharge the UPS for 24
1. Remove
the
battery
is
2. Change Battery.
1.
On/Off
is
pushed
1.
1. Charge the battery.
2. If the battery is near the end
1. If Utility is normal, connect
A03-PE601
Solution
rating.
properly.
hours.
some
uncritical
load.
Please try again.
Contact Atlantis Land.
of its service life, you have
to replace the battery.
Utility first then restart UPS.
Pag. 22
Publicité
Table des Matières
