Atlantis Land OnePower A03-PE601 Manuel page 24

LED/Button Information
To Control on/off the UPS when Utility is normal. Push
Main Switch ( )
the "Main Switch" for 3 seconds, then release it when
the LED is extinguished
To enable "DC-Start" Function when Utility fails. (To
enable DC Start properly, you are recommended to
connect <80% output load with the UPS only). P.S.
Make sure the computer connected to the UPS is
switched on before enable the "DC-Start" function. You
are not recommended to add some other computer or
peripherals after DC-Start function is activated.
Green LED remains standstill when Utility is normal.
LED Line ( )
Green LED flashes every 2 seconds and simultaneously
buzzer
continuously when Utility failure.
Green LED flashes once every 0.5 second and
simultaneously buzzer alarms (beep once every 0.5
second) continuously when utility failure and battery is
Low.
Green OFF: to avoid UPS from over-discharge, the UPS
shuts itself down when the battery voltage is too low.
OnePower UPS 600VA/300W(EN)
alarms (beep once
A03-PE601
every 2 seconds)
Pag. 19