Operation Test; Front Panel Explanations - Atlantis Land OnePower A03-S1001 Manuel

1.7 Operation Test

1. Connect the UPS to the wall receptacle.
2. Push on the Main Switch to check the Green Line (
3. Connect your computer equipment with sockets of the UPS and pull off
the input power cable of the UPS from the wall receptacle to check the
Line (
Meanwhile, please check if alarm buzzer is beeping.
4. Try the field working condition by running some application programs on
your computer and repeating step.
5. Check if the UPS is initiated properly to support continuous operation.
IMPORTANT NOTICE: Plug the UPS into the wall outlet to charge the UPS for
over 10 hours before using the UPS.

1.8 Front Panel Explanations

On the front panel You can found 4 LED for an easy diagnostic.
LED
LED Line ( )
LED Inverter (
) and Inverter(
Information
Green LED remains standstill when Utility is
normal.
Green LED flashes every 2 seconds when the
UPS is in Battery charging mode.
Green LED remains standstill and simultaneously
buzzer alarms continuously when the UPS is in
overload condition.
Yellow LED flashes every 2 seconds and
)
simultaneously buzzer alarms continuously when
Utility failure.
A03-S1001/A03-S1501
OnePower Line Interactive UPS (EN)
) LED are flashing every 2 seconds.
) LED is on.
Pag. 20