Connect Telephone / Network Surge Protection And Usb - Atlantis Land OnePower A03-S1001 Manuel

OnePower Line Interactive UPS (EN)
Caution: Do not connect a laser printer to the outlets. These UPS outlets
provide battery power and surge protection to the equipment when utility voltage
is outside acceptable limits.
1.6 Connect telephone / Network Surge protection and
USB
Connect a single line telephone or a 10 base-T / 100 base-T network cable into
the RJ-45 / RJ-11 telephone / network surge protection "IN" jack on the back of
the UPS. Connect from the "OUT" jack with telephone cable (supplied) or network
cabling (not supplied) to a fax modem or network port.
Connect the supplied interface cable to the USB computer interface port on the
back of the UPS. Connect to the computer. See software document for
installation instruction.
A03-S1001/A03-S1501 Pag. 19