Troubleshooting - Pro-Point 8718090 Manuel D'utilisateur

8718090
1. If the generator has been running, allow it to cool for at least half an hour before cleaning.
2. Clean all exterior surfaces.
3. Touch up any damaged paint.
4. Coat other areas that may rust with a light film of oil.
DISPOSAL
Recycle a generator damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for electronic devices,
batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing uncontrolled discharge of waste oil.

TROUBLESHOOTING

Contact Princess Auto Ltd. for a solution if the generator does not function properly or parts are
missing. If unable to do so, have a qualified technician service the generator.
PROBLEM(S) POSSIBLE CAUSE(S)
Engine will not 1. Engine is cold.
start.
2. Fuel valve in OFF position.
3. Engine switch is in OFF position.
4. Engine oil is low.
5. Out of fuel.
6. Bad fuel, engine stored without
7. Spark plug is faulty or improperly
8. Engine is flooded.
9. Spark plug fouled/fails to produce
10. Fuel filter restricted, carburetor
Engine will not 1. Power cord damaged.
start, electric
2. Battery dead.
start.
3. Fuse tripped.
4. Breaker tripped.
Engine lacks 1. Filter element restricted.
power.
2. Stale fuel, engine stored without
3. Fuel filter restricted, carburetor
No power 1. Main switch is not closed.
generated
2. Contact of socket is not sufficient.
3. Rated speed of generator cannot
16
15,000W Gasoline Generator with Electric Start
treating or draining gasoline, or
refueled with bad gasoline.
gapped.
a spark.
malfunction, ignition malfunction,
valves stuck, etc.
treating or draining ethanol based
gasoline.
malfunction, ignition malfunction,
valves stuck, etc.
be reached.
SUGGESTED SOLUTION(S)
1. Move choke to CLOSED position until warm,
then move to the OPEN position.
2. Move to ON position
3. Move to ON position
4. Fill with the recommended oil to the
proper level.
5. Refuel.
6. Drain fuel tank and carburetor. Refuel with
fresh gasoline.
7. Gap or replace spark plug
8. Move choke to OPEN/RUN position
9. Remove and clean spark plug. Check
electrode spacing and set the gap to the
correct dimension. Replace spark plug if
damaged. Ensure the spark lead is installed
and wire is connected.
10. Replace or repair faulty components as
needed. Contact Princess Auto Ltd or take
engine to an authorized service center if
necessary.
1. Repair or replace power cord.
2. Recharge or replace battery.
3. Replace fuse.
4. Reset breaker.
1. Clean or replace filter element.
2. Drain fuel tank and carburetor. Refuel with
fresh gasoline.
3. Replace or repair faulty components as
needed. Contact Princess Auto Ltd. or take
engine to an authorized service center if
necessary.
1. Turn main switch to ON position.
2. Adjust the feet of the socket.
3. Adjust according to requirement in manual.
For technical questions call 1-800-665-8685
V1.0