Freezer; Preparation; Things To Be Done For Energy; Initial Use - Beko BUFR2715PSIM Manuel D'utilisation

4

Preparation

4.1. Things to be done
for energy saving
Connecting the product to electric
energy saving systems is risky
A
as it may cause damage on the
product.
• Do not leave the doors of your freezer
open for a long time.
• Do not put hot food or drinks in your

freezer.

• Do not overload the freezer, cooling
capacity will fall when the air
circulation inside is hindered.
• In order to store maximum amount
of food in the freezer compartment,
the icematic, available in the freezer
compartment and easily removable
by hand, shall be taken out. Net
volume and energy consumption
values declared on the power data
plate of your freezer are measured
and tested by removing the icematic.
Do not remove the shelves inside the
freezer compartment and on the door
of freezer compartment shall not be
removed and they shall always be
used they provide ease of use and
efficiency in energy consumption.
• Airflow should not be blocked by
placing foods on the sides of the
freezer compartment fan. A minimum
distance of 1 1/4"(3 cm) shall be
provided on the sides of protective fan
cover.
• The baskets/drawers that are
provided with the chill compartment
must always be in use for low energy
consumption and for better storage
conditions.
• Food contact with the temperature
sensor in the freezer compartment
may increase energy consumption of
the appliance. Thus any contact with
the sensor(s) must be avoided.
• Depending on the features of your
product, thawing frozen food in
freezer compartment will both
provide energy saving and preserve
the food quality.
• Do not allow contact of the food
with the freezer compartment
temperature sensor shown in the
figure below.

4.2. Initial use

Before starting to use your freezer,
ensure that all preparations are made
in accordance with the instructions in
sections "Instructions for safety and
environment" and "Installation".
• Run the product without putting any
food for 6 hours and do not open its
door unless certainly required.
C You will hear a noise when the
compressor starts up. The liquids
and gases sealed within the
refrigeration system may also
give rise to noise, even if the
compressor is not running and this
is quite normal.
C Front edges of the product may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
C In some models, the instrument
panel automatically turns off 5
minutes after the door has closed.
It will be reactivated when the
door has opened or pressed on
any key.
12 /20 EN
Freezer / User Manual