Detach The Dome Camera From The Easy Adaptor; Open The Dome Cover - Eneo MPD-62V2812P0A Mode D'emploi

CAUTION:
Extreme care should be taken NOT to scratch the bubble dome surface
while the camera installing or adjusting.
Care should be taken the cable is NOT to be damaged, kinked or exposed
in the hazardous area.
Tighten enough the dome cover fixing screws so that there should be NO
gap between Lens hood and clear bubble to avoid the light inflow from
IR LEDs.

Detach the dome camera from the easy adaptor

Push the hook on the dome base and swing the dome base to counterclockwise. Then
detach the dome camera from the installed easy adaptor.

Open the dome cover

1. Insert wide side of Open Tool into the lock of Dome Cover.
2. Hold the Dome housing with one hand and turn the open tool until Dome Cover
is sufficiently open.
3. Once Dome Base and Dome Cover are detached, press the edge of Dome Cover
and pull it down with hands.
EN
9