Operating Instructions; Using Osd Controller; Description Of The Osd Control Operation; Using Video Format Switch - Eneo MPD-62V2812P0A Mode D'emploi

Operating instructions

Using OSD controller

Setup menu can be accessed and controlled by OSD control joy stick on the gimbal of the
camera unit. Five commands are available with the joy stick. The design of OSD could be
different according to the Model.

Description of the OSD control operation

1. SET Key (●) : Access to the menu or enter the setting. To enter the main menu,
press the Set Key down.
2. UP/DOWN Key (▲/▼) : Choose the desired sub-menu and to move the cursor up or
down.
3. LEFT/RIGHT Key (◄/►) : Set up the value of the selected menu. Used to adjust the
desired menu selection and to move the cursor left or right.
If OSD menu is adjusted in specific video format, adjusted value is applied to only
i
related video format. For example, if the menu is adjusted in CVBS mode, adjusted value
is applied to CVBS video only.

Using Video Format Switch

DIP SWITCH setting

The DIP SWITCH setting has first priority.
If the switch is set to CVBS, only CVBS output is available for both main video output and
sub-out. Please be advised that camera generates only one video output for both main
video output and sub-out. It takes 3~5 seconds when video format is changing. The
default DIP SWITCH setting is CVBS mode.
EN
11