Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. Installation
3.1 Supplied Accessories
• Power supply unit (optional)
• Operating instructions
• 3mm Allen wrench key, bag of screws
3.2 Opening the Housing for Adjusting the Angle of View
1.
Before the housing is opened, the sunshield (only for the weatherproof model) is to be moved so that the Allen screw (a) located in the housing middle section (1)
is accessible.
2.
This screw is to be screwed into the housing by rotating it clockwise until it reaches the stop.
3.
The housing body (middle section) can then be taken off by pulling it forwards. The middle section of the housing is fixed to the camera mounting rail by an
arrester cable.
4.
When handling the inner components the middle section can hang on the arrester cable.
5.
If required, the arrester cable can be hung on the camera mounting rail so that the middle section can be dismantled from the housing end and mounting arm.
Fig. 1
A Turning it clockwise = open
B Turning counterclockwise = close
A
B
a
13
a
1
Publicité
Table des Matières
