Publicité
Les langues disponibles
Les langues disponibles
The appliance is not designed to be an integrated appliance.
To ensure adequate ventilation, a minimum clearance of 30 cm to
the top and 5 cm to the back must be observed.
Do not install near heat sources such as hobs, radiators, underfloor
heating etc. If installation near a heat source cannot be avoided,
use an appropriate insulation panel or maintain the following
minimum clearances to the heat source:
− To electric or gas ovens or similar: approx. 3 cm
− To oil or coal-fired ovens: approx. 30 cm
− If installed next to another cooling appliance, a distance to the
side of 10 cm is required.
3.3.2. Before connection
DANGER!
Risk of electric shock!
There is a risk of electric shock due to live parts.
After installing the appliance, check that the mains connection
cable is not squashed or damaged.
Do not operate the appliance if it has been visibly damaged or the
mains cable or plug is defective.
In the event of damage, contact our Service Centre.
3.3.3. Mains connection
Connect the appliance to a properly installed safety socket which
is easily accessible and close to the place of installation. The local
mains voltage must correspond to the technical specifications for
the appliance.
The power socket must be easily accessible so that you can unplug
the appliance from the mains quickly if necessary.
WARNING! Ensure the mains cable is out of harm's way and will
not trip people up. Do not use an extension cable.
WARNING! Do not allow the mains cable to become trapped or
damaged during installation.
English -45
Publicité
