FAZUA PEDELEC Notice Originale page 12

EN
Operation
Requirements
For running the eBike drive system, following requirements must be followed:
• The Battery Pack is sufficiently charged, inserted and turned on (see
Battery Pack Instructions).
• Drivepack (1) is mounted in the eBike.
• The speed sensor is properly connected to the Bottom Bracket and
spoke magnet justly placed (see Bottom Bracket Instructions).
Switching eBike System On/Off
The system can be operated by a FAZUA approved Remote. Once the
Drivepack (1) is mounted in the eBike, the system can be switched on by
simply pressing any of the Remote buttons (see Remote Instructions).
The system output power depends on the support level settings on the Remote.
When you stop pedaling, or a speed of 25 km/h is reached, the support from
the drive system is gently switched off. The system switches on again when
you start pedaling and the speed is below 25 km/h.
There are different ways to switch off the system:
Press and hold the middle button of the Remote for 2 s (see Remote
•
Instructions).
Unmount the Drivepack (1) from the bike.
•
Switch off the Battery Pack (see the Battery Pack Instructions).
•
• Let the eBike enter into inactivity.
10