Publicité
Momentary Handle
(A) When handle is pushed forward the spray jets shut off.
Brush Switch
(B) ON\OFF switch for brush. Flip switch up to (I) position to turn on the brush motor. Flip switch to (o) position to shut off brush
motor.
Vacuum Switch
(C) ON\OFF switch for vacuum. Flip switch up to (I) position to turn on vacuum. Flip switch to (o) position to shut off.
Spray Jet / Auxiliary Switch
(D) Power switch for spray jet and auxiliary function. Push the switch to the (I) position to turn ON the spray jets. Push switch to (II)
position to use the Off -aisle wand. This will power the auxiliary outlet and will turn the water pump on for the auxiliary connection.
Note: Make sure to turn off the brush motor when this switch is in the auxiliary mode, or damage to carpet may occur.
8
Solution tank In-line Filter
The In-line Filter (B) should be cleaned regularly. To clean:
1.
Close the Shut-off Valve (C) by turning the handle 90°
clockwise.
2.
Next, twist the Filter Cap (A) counterclockwise.
3.
Pull the filter out to clean filter and cap.
4.
Place filter back into cap, twist cap clockwise onto
filter body, tighten by hand.
Note: Using tools to tighten may damage plastic threads.
5.
Turn Shut-off Valve (C) counter clockwise to open.
Solution tank Drain Hose
The solution tank may be drained by removing the Solution
Tank Drain Hose (A) from the Hose Barb (B) and routing
the hose to a floor drain.
Publicité
