Publicité
Handle Assembly
The 900 XT Handle Assembly (D) is not assembled on the machine
when shipped. Follow the instruction on the previous page
to connect the handle assembly to the machine.
A - Handle Adjustment Knob
B - Shoulder Bolt
C - Cover
D - Handle Assembly
E - Screw
F - Cord Relief
Back & Bottom
A - Twist Lock Power Connector
B - Handle Adjustment Knob
C - Auxiliary Power Outlet (For Motorized Tool Only)
D - Recovery Tank Dump Hose
E - Brush Pressure Adjustment Knob
F - Off Aisle Wand Water Female Quick-Connect
G - Vacuum Hose Connection Point
H - In-Line Solution Filter
J - Vac Shoe
K - Brush
L - Brush End Cover
M - Spray Jets (2)
N - Brush Motor
P - Solution Tank Drain Hose
Handle / Control Panel
A - Momentary Spray Shut-Off
B - Brush Switch
C - Vacuum Switch
D - Spray Jet / Auxiliary Switch
Circuit Breakers
The circuit breakers are located on bottom and rear of the
handle assembly.
1.
BRUSH MOTOR BREAKER - 1.5 Amp
2.
VACUUM PUMP BREAKER - 12 Amp
3.
SPRAY JET PUMP\AUX POWER & PUMP BREAKER - 1.5amp
If any of the functions above are not operating, check if the
circuit breaker buttons have tripped. Press to reset.
7
Publicité
