Publicité
Cord Storage
The 900 XT is supplied with a detachable cord for ease of storage.
•
Regularly inspect cord for signs of damage. If cord is damaged replace immediately.
•
Do not use with damaged cord or plug. If appliance is not working as it should, has been dropped, damaged, left
outdoors, or dropped into water, return to service center.
•
Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around sharp edges or corners.
Do not run appliance over cord. Keep cord away from heated surfaces.
•
Do not unplug by pulling cord. To unplug, grasp the plug, not the cord.
•
Do not handle plug or appliance with wet hands.
•
This equipment should be stored indoors and not exposed to rain.
Operating Instructions
Filling the 900 Xt
Remove clear solution cover lid from front of machine, or use the supplied faucet fill hose, by pulling hose out
and holding rubber inlet against faucet. Fill solution tank with desired amount of warm water and add liquid
cleaning chemical. DO NOT USE powdered cleaning chemicals. Powders are unlikely to dissolve thoroughly,
resulting in clogging the inline solution strainer and other fittings. This can reduce or stop solution flow to
the pump and spray jets.
Carpet should be thoroughly vacuumed and obstacles relocated before beginning the cleaning cycle. Heavy
traffic lane areas should be pre-treated or spotted for best results.
to Begin Cleaning:
1.
Always work away from the cord.
2.
Machine operates by pulling backwards over carpet.
3.
The recovery dome lid should be properly seated on Recovery Tank for proper vacuum recovery.
normal Cleaning Mode
1.
Turn on vacuum switch.
2.
Turn on brush switch.
3.
Turn on solution pump to position 1.
4.
Adjust brush pressure at rear of machine, until brush pressure gauge reads in green zone.
5.
Solution pump should be turned off by either using the momentary valve, or flip the switch spray jet to the center
position before the end of each cleaning pass.
During the cleaning cycle, care should be taken not to allow foam to build up in the recovery tank. If this should happen,
the machine should be turned off. Defoamer should be added to the recovery tank only, never into the solution tank. Foam should
not be seen inside the right side of the dome lid.
The recovery water level can be viewed from the operator's position of the machine through the left side of the visible recovery
dome. The 900 XT has a float ball shut off located in the recovery tank that cuts off suction to the vacuum hose. When the recovery
tank is full, the vacuum motor will become noticeably louder and the machine will not pick up water. Recovery tank must
be emptied. (NOTE : Never tilt machine completely back with recovery tank in place. Always remove tank and set to the side before tilting
complete machine.) To empty the recovery tank use the recovery tank dump hose (page 7, Back & Bottom, item D). Unclip the hose from
the tank and turn the cap a quarter turn counter-clockwise and dump waste water into a floor drain or slop sink.
12
Maximum Water
Temperature
Publicité
