Publicité
Handle Adjustment
The handle was designed with operator comfort in mind. The angle position of the handle can be adjusted to suit the needs
of the operator.
10
Figure 1
Removable Recovery tank
To remove tank:
1.
Unclip dump hose from solution tank.
2.
Pull recovery tank straight up.
To replace tank:
1.
Feed dump hose through opening in solution tank.
2.
Lower tank into place. Recovery vacuum inlet will rest
on vacuum connection tube (See page 6, items L & M)
3.
Clip dump hose to solution tank.
Angle Adjustment
The handle can be adjusted without tools by loosening
the Handle Adjustment Knob (A) and rotating the handle
to the desired position.
Cord Relief
Use cord relief to prevent cables from disconnecting. Lock the
cord in place by looping the cable and threading the cable
through the relief, then pull the cable down so it locks into
place as shown in figure 1.
Publicité
