Toshiba RBC-AX23UW-E Manuel Du Propriétaire page 8

Wireless Remote Controller Kit
3
Correct Usage
Auto, Heat, Dry, Cool, Fan
• The automatic cooling/heating and
heating functions are not provided for
cooling only types.
• Auto is available only in a Heat Recovery
Multi System.
Power
Turn on the power switch on the remote
controller 12 hours before starting operation.
* The remote controller is disabled for approx.
1 minute after the indoor unit has been
powered on. This is normal. (The signal from
the remote controller is received, but the
receive data is discarded.)
2
3
1
Push .
2
Select an operation mode with the
button.
• Select Auto
, or Fan
3
Select fan speed with
• When the Auto mode is selected, the fan
speed changes automatically. The fan
speed does not change automatically in
the Fan mode.
4
Select the set point temperature by
pushing the
• Temperature setting is not available for the
Fan mode.
7-EN
, Heat , Dry , Cool
.
button.
or buttons.
5
Stop
Push .
The operation lamp goes off, and the
operation stops. In the COOL, DRY, or AUTO
(cooling) mode, the fan runs for 10 minutes (or
more) for self cleaning.
• If the room is not well heated with FAN
during heating, change the fan
speed to FAN
Although selected fan speed is displayed,
some indoor unit types are not provided
with the air volume change function. (Fan
speed is constant.)
• If the unit operation cannot be stopped
in the usual manner, turn off the power
switch and contact the dealer from
whom you purchased the air
conditioner.
4
Auto mode
1
When connected to a Heat Recovery Multi
System, the room is automatically cooled or
heated depending on the difference between
the temperature setting and the room
temperature.
– 7 –
Owner's Manual
or FAN .