Toshiba RBC-AX23UW-E Manuel Du Propriétaire page 4

Wireless Remote Controller Kit
2
Part Names and Functions
Remote Controller (WH-H1JE2)
• Up to 8 indoor units in a group can be controlled by one remote controller.
1
2
3
4
5
6
7
8
9
10
1
Transmitting part
2
ON/OFF button
Starts and stops the air conditioner
alternately.
3
Mode button
Selects desired operation mode.
4
Fan speed button
5
Timer set button
Use to setup the timer. (See page 8)
6
Filter button
No function
3-EN
ADR
ADR
SENSOR
ACL
7
RESET button
Used after batteries are replaced or the slide
11
switch is switched. (See page 10)
8
Slide switch (See page 10)
9
Battery compartment (See page 10)
12
10
Cover
Slide the cover downward holding its both
13
sides.
11
Remote controller sensor
Senses the ambient temperature when the
14
remote controller is selected with the sensor
button.
12
LCD
15
Displays the air conditioner operation mode.
16
(This illustration shows all display contents.)
17
13
AUTO louver display differs according
18
to the installed unit. (See page 9)
14
Setup temperature button
Adjusts the set point.
Select the desired set point by pushing these
buttons.
15
Swing/louver direction button
(See page 9)
16
Address button (See page 12)
17
Ventilation button
Use this when a ventilation fan or other unit,
purchased on the market, has been
connected. (no function)
18
Sensor button
Selects the temperature sensor of the remote
controller.
The temperature sensor of the indoor unit is
selected by default. While the indoor unit
temperature sensor is selected,
displayed on the display.
– 3 –
Owner's Manual
is