Operating Tips; Starting The Dishwasher; Adding A Forgotten Item - Maytag Jetclean MDB6650 Guide De L'utilisateur

Delay
Controls at a Glance
Resume
Control Lock Option
The control touchpads can be locked to prevent unwanted
use. If this feature is activated between cycles, the dish-
washer cannot be operated until the controls are unlocked.
If desired, the controls can be locked after a cycle or delay
has started.
Note: This option does not lock the door, only the dish-
washer controls.

Operating Tips

Starting The Dishwasher

1
After loading the dishwasher and adding detergent,
close the dishwasher by pressing the door until the
latch clicks.
2
To start the dishwasher, firmly press the desired
cycle and options pads. After a pause, the fill will
begin. To prevent unplanned cycle or option
changes, these selections are "locked in" after 1
minute.
3 The indicator lights for the selected cycle and
options will glow.
4
To cancel an option, press the pad again. To cancel
a cycle, press the Drain/Off pad.
Note: If a cycle or option pad is pressed after the
selections are "locked in", the indicator light above
the Control Lock pad will flash five times.
(continued)
Setting the Control Lock:
1 Press the
An indicator light above the pad will illuminate when
2
the controls are locked.
To Cancel:
1
Press the
2
The indicator light will go off.
Note: If a cycle or option pad is pressed after the con-
trols have been locked, the indicator light above the
Control Lock pad will flash five times.

Adding a Forgotten Item

For best cleaning, the forgotten item should be added early
in the cycle.
1
Press the Delay/Resume pad or unlatch the door.
2
Wait for the water circulation to stop.
3
Open the door and add the item.
4
Close and latch the door.
• If Delay/Resume was pushed, push it again to
restart the dishwasher.
5
After five seconds, the cycle resumes automatically at
the point of interruption.
Note: Extended interruption of the wash cycle is not
recommended.
7
pad for three seconds.
pad for three seconds.