Controls And Their Functions; Front View; Rear View - Panasonic BT-LH1800P Mode D'emploi

Control and Their Functions

Front View

POWER
MENU/
A B S OPTION
EXIT
INPUT SELECT
! @
! Power switch
This is the main power switch.
With power ON, the upper LED (green) of the switch is
lighted.
@ Input select button
This is the signal input select button.
The input line of the button pressed is selected, then the
upper LED (green) is lighted.
A: Line-A (composite input)
B: Line-B (composite input)
S: S-Video (S-video input)
OPTION: Option unit
# Menu select button
Used for menu display, adjustment and setting.
MENU/EXIT: Push when displaying a menu and getting out
of the menu.
: Push when moving the cursor up/down or se-
lecting an item.
ENTER: Push when getting into a downward menu.
$ BLUE ONLY/HV DELAY button
BLUE ONLY: With the button pushed, picture quality can
be adjusted by color lever.
When it is pushed again, the mode returns
to normal display.
HV DELAY: SYNC, blanking, and burst flag can be ob-
served.
Normal, H-Delay, V-delay and HV-Delay are
repeatedly displayed each time when
pushed. It doesn't work when HD ZOOM is
used.
% Picture adjusting knob
(Hue/chroma/brightness/contrast)
Adjustable with the knob pushed and popped out, and re-
turned to preset value with it pushed in.
When set to a value other than the standard preset value,
the upper LED (amber) of adjusting knob is lighted.
BLUE HV
ENTER ONLY DELAY
MENU
PHASE CHROMA BRIGHT CONTRAST
# $ %

Rear View

1
2
7 8
3
qS
M
4
5
6
1 LINE-A connector
This is the composite input connector A (BNC). (With
through-out type)
2 LINE-B connector
This is the composite input connector B (BNC). (With
though-out type)
3 S-video input connector
This is the S-video signal input connector. (With though-
out type)
4 REMOTE terminal
This is the REMOTE terminal (9-pin D-Sub).
5 SIGNAL GND terminal
This is the signal GND terminal.
6 AC power input socket
This is the AC power socket. Connect the attached power
cord. (Slip-off preventive fittings attached)
7 HD-SDI connector
This is the HD-SDI input connector (BNC). (With active
through-out type) [In use of optional HD SDI INPUT UNIT
(BT-YA300P)]
8 SDI connector
This is the SDI input connector (BNC). (With active through-
out type) [In use of optional SDI INPUT UNIT (BT-YA200P)]
9 – qR COMPONENT/RGB connector
This is the analog component/RGB input connector (BNC).
(With through-out type)
Also provided with external sync connector. [In use of op-
tional COMPONENT/RGB INPUT UNIT (BT-YA100P)]
qS VESA mount
9
qR
qS
7, 8, 9 to qR are options.
5