Troubleshooting - Hamron 009452 Traduction Des Instructions D'origine

6

Troubleshooting

Speak to your dealer if you cannot find the solution for the
problem in the troubleshooting table.
Problem
The lifting frames cannot be raised or lowered.
The lifting frames cannot be lowered.
The electric power unit gives no pressure.
The lifting frames have become stuck at
maximum height with no load.
The lifting frames cannot be raised from a fully
lowered position.
The hydraulic fluid is contaminated.
No button is pushed but the lifting frames are
slowly lowered.
The couplers are difficult to connect.
Abnormal noise during use.
2022_001
Make sure that the hydraulic hoses are not bent, clamped or leak. Release
the hose or repair the leak.
Make sure that the level of the hydraulic fluid. Refer to "4.3.1 To bleed the
hydraulic system" on page 29.
Make sure that the power supply to the hydraulic unit. If it is necessary,
turn the power on
Air has accumulated in the hydraulic system. Refer to "4.3.1 To bleed the
hydraulic system" on page 29.
Do a check if the lifting frames are loaded. If not, place a load on them
The product can only operate with a load on the lifting frames. Put a load
on the lifting frames.
Repair the power unit.
To lower from maximum height, the lifting frames must be loaded.
There must be space between the ground and the load that is to be lifted.
Replace the contaminated hydraulic fluid with new fluid of the same type.
Do a check that the lifting frames are locked in 1 of the locking positions. If
not, hydraulic fluid is slowly leaking and the lifting frames are lowered. Do
not leave the product if it is not fully lowered or locked in 1 of the 3 locked
positions.
There is pressure in the hydraulic system. Make sure that the lifting frames
are fully lowered. Push and hold the D button for a few seconds to release
the pressure to return as much hydraulic fluid as possible to the fluid
container. Speak to your dealer if the pressure is so high that it is not
possible to connect the couplers.
Lubricate the joints with white lithium grease.
Action
32