Installation Requirements - Oceanic OCEAHC180B8 Guide D'utilisation

4) In a cold climate, it is
advisable to install an
additional check valve to
minimize cold air return,
as well as a nonmetallic
thermal barrier to
minimize heat transfer
by conduction to the
outside. The valve must
be installed on the side
of the thermal barrier
where the air is cold.
The thermal barrier must
also be installed as close
as possible to the point
where the duct enters
the heated part of the
building.

Installation requirements

TO REDUCE THE RISK
OF FIRE, USE ONLY
METAL DUCTWORK.
Install this hood in
accordance with all
specified requirements.
To reduce the risk of fire
and extract air effectively,
make sure the exhaust duct
faces out. The extraction
mouth must not be open on
a space between two walls,
ceilings, attics, reduced
spaces or garages.
Warning: Failure to install
the screw fastener or to
observe these instructions
may result in electrical
hazards.
WARNING
CAUTION
13