Removing The Rear Lint Screen; Removing The Activepure/Rci Cell - EcoQuest Fresh Air Everest Guide D'utilisation

REMOVING THE REAR LINT SCREEN

To Remove:
Rear Lint Screen
follow steps 1 - 5
ActivePure/RCI cell
follow steps 1 - 9

REMOVING THE ACTIVEPURE/RCI CELL

8
3
3. Remove
back cover.
Press the
sides to
unlatch,
then tilt the
bottom out
to remove.
6
6. Unlock the
ActivePure/RCI
cell connector
by pressing on
the connector's
locking tabs.
8
8. Remove
two (2)
thumbscrews.
1
1. Unplug unit.
4
4. Remove
two (2)
thumbscrews
securing the
top of the lint
screen.
7
7. Pull the
connector
straight out
to unplug.
9
9. Remove the
ActivePure/RCI
cell from the
unit.
2
2. Remove
the back
cover
screw.
5
5. Remove
the lint
screen by
pulling
back the
top, then
lifting up
and out.
DISPOSAL OF A USED
ACTIVEPURE/RCI CELL
Please do not throw a used
ActivePure/RCI cell into the
garbage. The special germicidal
UVX bulb used in the ActivePure/
RCI cell contains a very small
amount of mercury. You may return
your used ActivePure/RCI cell to
EcoQuest for proper disposal. Send
the used cell to:
EcoQuest International
RCI Disposal
55 Marley Drive
Greeneville, TN 37743
WARNING: Do not operate
Fresh Air Everest without the
rear lint screen and back cover
properly installed.
ActivePure/RCI cells must be
replaced every 2 years, even if
the UV lamp is still operating.