Operation; Changing The Fuse; Placement Of Unit - EcoQuest Fresh Air Everest Guide D'utilisation

OPERATION

1 . Adjust the fan speed to your preference, keeping in
mind that higher fan speeds will give better results .
2 . Using the PURIFIER button, set the unit to RCI PUR .
ON for increased effectiveness .
Fan Speed
RCI PUR. OFF: Fan and ionization are on. The RCI cell is
turned off.

CHANGING THE FUSE

The fuse may be accessed by unplugging the cord from
the back of the unit, removing the back cover (see page
8), then pulling, or if necessary, gently prying the fuse out
using a small, straight screwdriver .

PLACEMENT OF UNIT

4
RCI Cell Setting
Place the unit as high as possible to insure
complete purification . (On top of a bookshelf,
high cabinet, etc .)
Suggested locations listed in the order of
preference:
1 . Nearest the source of the worst pollution .
2 . Near a cold-air return to thoroughly circulate
the benefits of your Fresh Air Everest
throughout the area .
3 . In the area most heavily used to achieve
maximum benefit .
Fan Speed (Max)
RCI PUR. ON: Fan, ionization, and RCI cell is on. Use this
setting for general usage.
Use 1.6 Amp slow blow fuse.
Note:
• The rear of the unit should always
have at least one inch of open
area to allow unrestricted airflow .
• Point the unit towards the
center of the room for maximum
dispersion of ions .
• To prevent injury, be sure the
power cord is not accessible to
small children .
RCI Cell Setting