Publicité
Les langues disponibles
Les langues disponibles
4
Explanation of the installation/
removal of the lamp attachment
● For cases where you want to use it and the installation situation of the projector main unit shows a
downward slope above 45 °, it is necessary to use the lamp attachment included in the set, or a
separately sold lamp attachment (PC010685599). For cases with less than 45 °, please do not attach
the lamp attachment.
Lamp attachment replacement procedures
1
Insert the "a" section of the lamp attachment into the "A"
section of the lamp unit. Hang the lamp attachment into
the clasp-shaped part of the of the lamp unit
Figure 1-1
2
Fit the "b" section of the lamp attachment (see Figure 1-2)
into the clasp-shaped part of the lamp unit by pressing the
former into the latter
58
This manual downloaded from http://www.manualowl.com
Maintenance
lamp attachment
Figure 3
Figure 4
Figure 1-2
In case the lamp attachment is bent in any other
direction than stated in the written instructions, or if it
is modified, or remodeled, the lamp attachment will be
damaged or break off. This may lead to failure of the
main unit of the projector.
Moreover, in case it is repeatedly installed and re-
moved, it may be possible that the "a" section of the
clasp section breaks off. In this case, please purchase
and use a new replacement lamp attachment.
As the folding section of the "b" section is fragile when
bending it in the direction of the arrow, please be
careful.
lamp unit
A
"
"
Figure 2
CAUTION
Publicité
