JVC DLA-F110 Manuel D'instructions page 46

3
Adjustments and settings in the menu (continued)
[1-2-2] Custom Gamma
Custom 1~3
Correction Value
Gamma Adjustment The gamma curve for "green" is being displayed as being representative. If "white", "red,"
White
Red
Green
Blue
Reset
(*)
Gradation at the
selected point.
46
This manual downloaded from http://www.manualowl.com
Operation
[1] It is possible to select a gamma curve adjustment for Custom 1, 2, and 3 under the
"Gamma" of the picture adjust and then save it.
Please adjust to your preference.
(*) Initial values of Custom 1, 2, and 3 are the same as for "Normal".
(*) Please refer to the figure at the bottom of the menu in two frames for adjustment.
(*) It is recommended that you read "Gamma Curve" (page reference: 53) for hints about
adjustment.
You can choose to add the underlying gamma curve adjustment.
(*) Can choose any setting, as the default gamma curve will always appear linear.
Settings: Normal, A, B, C, D
(brightens in particular dark to intermediate parts) 1.8 to 2.6 (darkens in particular dark to
intermediate parts) in the range of values with increments of 0.1
"green" or "blue" are selected, the corresponding color curves are displayed.
Place the cursor on a gamma curve with 12 points with the buttons for left and right, and
then use the buttons for up and down buttons to move those points up or down.
Red, green and blue can be adjusted at the same time.
It is possible to adjust the gamma curve of red.
It is possible to adjust the gamma curve for green.
It is possible to adjust the gamma curve for blue.
The same data as for the "Normal" mode are used.
(*) When you exit the adjustment menu of Custom Gamma, please save the adjustment
values.
You can return to the original data, which should be saved.
Picture Adjust
Custom Gamma
>>
Correction Value
Custom1
Custom2
Custom3
Exit
MENU
Select
1023
White
Red
Green
Blue
512
Reset
0
Operate Back
BACK
Normal
Gamma curve
Gradation diagram
corresponding
50
100(%)
to the gamma
curve.
[Normal]