Energy Saving Modes - BH ATOM X Manuel De L'utilisateur

ATOM

5.3 Energy Saving Modes

The battery has been designed to ensure a long service life. This is possible thanks to the energy saving modes
5.3.1 Transport Mode (only during the first use)
In order to minimise internal consumption while transporting the bicycle from the factory to the store, the battery
is in Transport mode.
The user can finally exit this Transport mode by charging the battery to 100% before its first use.
ATTENTION
5.3.2 Stand By Mode
In order to minimise internal consumption, the battery automatically switches to Stand By mode. This happens
automatically when the system detects no charging, no discharging and no communication with the battery for
a period of 10 minutes. So, for example, this mode will automatically turn off the display panel after 10 minutes
without use, if the user has left it on after parking.
The user can exit this Stand By mode by simply turning on the bicycle's display panel.
5.3.3 Deep Sleep Mode
In order to protect the battery during long periods of inactivity or storage (for example, during the winter),
the battery automatically switches to Deep Sleep mode.
This happens automatically when any of the following situations occur:
A) If the charge level of the battery is below 1%, the battery goes into Deep Sleep mode when the battery
has continuously been in Stand By mode for 10 minutes.
B) If the charge level of the battery is below 10%, the battery goes into Deep Sleep mode when the battery
has continuously been in Stand By mode for 48 hours.
C) If the charge level of the battery is below 40%:Deep Sleep mode is activated when the battery has
continuously been in Stand By mode for 14 days.
D) If the charge level of the battery is below 80%:Deep Sleep mode is activated when the battery has
continuously been in Stand By mode for 30 days.
The user can exit this Deep Sleep mode by holding down the battery's SOC button (which
checks the charge level) for 5 seconds or starting to charge the battery with the charger.
2 flashes of all LEDs
1 flash of all LEDs
If the battery does not charge fully, the Transport mode will not deactivate,
repeatedly entering this mode quickly for its protection.Remember to fully
charge the battery to finally deactivate the Transport mode.
Pressing SOC button 5 sec
Stand By Mode
Deep Sleep Mode
USER MANUAL
EN
49