EWT CLIMA ML Mode D'emploi page 20

ELECTRICAL
WARNING – THIS APPLIANCE MUST BE EARTHED
This heater must be used on an A.C. ~ supply only and the voltage marked on the heater must correspond to the supply voltage.
POSITIONING THE HEATER
Ensure that curtains and furniture are not positioned close to the chosen position.
WARNING: Please ensure the minimum clearance dimensions indicated in Fig.1 are maintained.
ASSEMBLY
The appliance is now ready for use.
USING THE HEATER
IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER.
Before using the heater ensure that all warnings and instructions have been carefully read.
To activate the heater, after installation or assembly, simply plug it in.
cause a small amount of fuming. This is quite normal – the fumes are non-toxic and will quickly disappear.
CONTROLS
mains power indicating Neon lens and a boost fan.
Thermostat
The thermostat controls the heat output according to the room temperature.
This ensures that the heater will not produce heat unnecessarily when the room is warm.
To set the temperature you require, gradually turn the thermostat knob clockwise until the desired temperature is reached.
Allow some time between increments for the room temperature to stabilise.
Alternatively to heat a cold room quickly, turn the thermostat knob to the Max position. When the room has reached the
desired temperature, turn the thermostat knob anticlockwise until the thermostat clicks off. The heater will then automatically
maintain this room temperature.
The thermostat also has a frost protection setting marked '
This setting is useful in areas such as garages to prevent frost damage. If the thermostat is set to its minimum setting '
heater will cycle ON and OFF to maintain a temperature of approximately 5°C to help protect against frosty conditions.
20
FR
'.
DE EN NL PL SV
', the