Publicité
Les langues disponibles
Les langues disponibles
During the installation of the cooker hood, always wear protective handgloves to prevent
injuries.
DISMANTLING AND REPOSITIONING OF THE GREASE FILTERS
Switch the light off and wait untill the bulbs are completely cooled down.
Follow the steps as shown in the pictures.
To dismantle the grease filter, press the handles, overturn the filters and remove
them.
To remount the grease filters, put the rear part of the grease filter into its seat, press
the handle, insert the front part of the filter and release the handles.
FITTING AND REMOVAL OF EVENTUAL CARBON FILTERS
If you want to use the hood as filtering it is necessary to mount the carbon filters as it is
shown in the pictures of the C series. The carbon filters are OPTIONAL and they have to
be bought in a separate way.
There are carbon filters that need replacement after use and carbon filters that can be
regenerated. In case of use of carbon filters which can be regenerated follow the
instructions enclosed to the filters.
GENERAL WARNING
The pipe must be heat, flame and corrosionproof. The manufacturer strongly advises
against the use of reducers or pipes with different diameter to the hood outlet pipe, and
pipes made of flexible aluminium because performance is diminished and noise level
increased.
The end part of the pipe, on the outside of the hole on the wall, must be of such a shape
to avoid rain, gusts of wind or other foreign bodies getting into the pipe. Should there be
any doubt, contact anyone specialising in the installation of gas or ventilation system.
ELECTRICAL CONNECTION
WARNING
The electrical connection can only be carried out by qualified professional personnel,
using standard material and state of the art installation methods. The manufacturer
declines any responsibility for installations carried out by unskilled persons and for
installations which are not in conformity with the standard norms concerning electrical
safety (both concerning methods and materials).
ELECTRICAL TECHNICAL DATA
The electrical technical data are visible inside the hood after the removal of the grease
filters.
CONNECTION TO THE POWER SUPPLY
The flexible feed cable supplied is already connected internally and emerges from the
hood near the air outlet duct.
It is possible to effect two types of electric installation:
fixed installation;
installation by means of plug on a socket.
21
Publicité
