Daily Use; Connecting; Activating Siri Assistant - Belkin CarAudio Connect FM Guide D'utilisation

DAIlY Use

sections
table of contents

Connecting

To connect to the CarAudio Connect FM:
1.
If you're already on a call or listening to music via a Bluetooth
headset, turn the headset off so that your phone is free to connect
to the CarAudio Connect FM.
2. Make sure there's power to the CarAudio Connect FM—the light ring
will be orange.
3. Turn on your car stereo, set the source to FM, and match the
frequency shown on the CarAudio Connect FM.
4. Tap the button and the CarAudio Connect FM will attempt to
re-connect with the same phone to which it last connected.
5. When successfully connected, the light ring will turn blue.
6. If you're already on a call or listening to music, the audio will transfer
to your car speakers.
note: If you don't tap the button to connect your phone, the light
in the button will stay orange. After 10 minutes of inactivity, the
CarAudio Connect FM will go into sleep mode and the light ring will
turn off. When that happens, tap the button to wake it and it will
immediately attempt to connect to the same phone to which it last
connected.
CarAudio Connect FM - Bluetooth
1 2
7
3 4
note: For European customers, regulations require that the FM
transmitter enter a Sleep mode and stop transmitting if no audio
data is being sent. If your FM transmitter enters Sleep mode,
tap the multifunction button to wake the unit. This will also
automatically answer an incoming call or begin playing music.
Only the Pairing button on the back of the unit will be active while
the FM transmitter is in Sleep mode. All other buttons will be
inactive.

Activating siri Assistant

To activate the Siri Assistant (if available), press and hold the multifunction
button for two seconds and then release.
5 6 7