Belkin CarAudio Connect FM Guide D'utilisation page 6

InITIAl seTUp
sections
table of contents
3. Store that frequency in memory by pressing and holding
one of the two MEM buttons. When the frequency is
stored successfully, the product will beep and MEMORY
1 or MEMORY 2 will show on the display.
CarAudio Connect FM - Bluetooth
1 2
or
3 4
4. Turn on your car stereo and set the input source to FM.
5. Tune your car stereo so that its FM frequency matches the CarAudio
Connect FM.
6. If possible, store the frequency in one of your car stereo's preset
buttons. Typically this is done by pressing and holding the chosen
preset button until the stereo beeps or gives some indication that
the frequency has been stored.
*If you hear static as you travel from one part of town to another, press the
ClearScan button again to find a better frequency.
3. Store that frequency in memory by pressing and holding one of the
two MEM buttons. When the frequency is stored successfully, the
product will beep and MEMORY 1 or MEMORY 2 will show on the
display.
4
or
5 6
3. Store that frequency in memory by pressing and h
two MEM buttons. When the frequency is stored s
product will beep and MEMORY 1 or MEMORY 2
display.
4. Turn on your car stereo and set the input source t
5. Tune your car stereo so that its FM frequency mat
Auto FM.
6. If possible, store the frequency in one of your ca
buttons. Typically this is done by pressing and h
preset button until the stereo beeps or gives som
the frequency has been stored.
*If you hear static as you travel from one part of town to
3. Store
two M
produ
displa
7
4. Turn o
5. Tune y
Auto F
6. If pos
button
prese
the fre
*If you hear