Use Procedure; Controller Start-Up; Starting The Pump; Pump Shutdown - Varian MicroVac 929-0200 Notice De Mode D'emploi

USE PROCEDURE

Controller Start-up

To start-up the controller, turn the main switch to ON,
after plugging the power cable into a suitable power
source.

Starting the Pump

The pump starts only when the controller is turned on
and the two interlocks (H.V. Cable and Remote
ON/OFF) are short-circuited. Please refer to section
"Technical Information" for further information.

Pump Shutdown

To shutdown the pump, turn the main switch placed on
the front panel to OFF.
MAINTENANCE
The MicroVac series controllers do not require any
maintenance interventions. Any intervention must be
performed by authorised personnel only.
When a fault has occurred it is possible to use the
Varian repair service or the "Varian advance exchange
service", that allows to obtain a regenerated controller
replacing the faulty one.
Before carrying out any work on the controller,
disconnect it from the supply.
If a pump is to be scrapped, it must be disposed of in
accordance with the specific national standards.
16
INSTRUCTIONS FOR USE
!
WARNING!
87-900-089-01 (E)