AnteaMED oppla Mode D'emploi page 39

Example: TI01M
The device will reply "Set updating time interval OK!" and then device will update the time by every 1 minute on the website.
3. Disable GPRS
Command: S0
The device will reply "GPRS OFF".
4. Reconnect GPRS
Reconnect the website via GPRS for real time tracking, please send
5. Setting a Heartbeat Packet Reporting Interval
The heartbeat packet function is used to keep the Transmission Control Protocol (TCP) connection open when the interval of scheduled GPRS reporting is long.
Command: HBxxM/H
Note: xx=00~99, M=Minute, H=Hour, The heartbeat packet function is only available for the PS1 and PS0 working mode.
Example: HB01H
After send the above command, the tracker will send the GPRS heartbeat packet to the platform every 1 hour in PS1 and PS0 mode. The heartbeat function is
used to keep the platform connection smooth, but GPS positioning data is invalid.
Command: HB00M
When the interval is 00, the heartbeat packet function is disabled.
6. Setting reporting time interval when no movement
When device has no movement for 5 minutes, GPS chip go to sleep. the time to send data to platform can be configured by user. (Once device
S2
- 19 -
GPS tracking system
EN