Jimmy HW9 Mode D'emploi page 8

Fill up clean water tank
1.Grasp the handle of the clean water tank to take off
clean water tank.
2.Pull out the clean water tank plug, open the injection
plug of the clean water tank, turn it to the side (about
90 degrees), expose the water injection hole, and fill in
clean water and cleaning solution inside.
3.Tighten clean water tank plug and make sure it is
tight.
4.Assemble clean water tank into floorhead until a
"click" sound is heard.(Fig 9)
Note:You can add the cleaning solution while filling
in clean water, the ratio is 1 bottle cap of cleaning
solution to one full tank of clean water.
Operation of machine
1.The on/off button of the machine is located on top
of handle, press on/off button to start working and the
Auto mode is enabled by default.The machine can
switch among Auto, Eco and Max mode by pressing
mode button. Press on/off button to stop working.
2.Press on/off button to start working and press the
water spray trigger to spray fan shape water flow from
front of floorhead, release the water spray triger and
water will stop spray.(Fig 10)
Notes:
1.The water spray button cannot be used together with the on/off button or the mode button.
2.When dirty water tank is full, the dirty water tank full indicator on LED screen will blink, and machine will
have voice reminding. Vacuum motor and brushroll motor will stop working immediately.
3.When the clean water tank is empty, press water spray button, there is no water spray out, clean water tank
empty indicator blinks and machine will have voice to remind user to add water.
4.When dirty water tank is taken out while the machine is working, the dirty water tank full indicator on LED
screen will blink and and machine will have voice reminding. Vacuum motor and brushroll motor will stop
working immediately.
5.After the machine finishes using, put it vertically on the charging base to ensure sufficient power for next
usage.
6.Please use the cleaning solution we provide to clean the product. Do not put high foam solution into the
cleaning tank,otherwise too much foam will be generated during using, which may penetrate into the machine
and cause danger.
Machine charging
1.Connect one end of the adapter to the charging stand, and the other end to the power socket;
2.Put the machine into the charging stand to enter the charging mode.The display screen shows the
percentage of battery power while charging. The display screen shows 100% power when the charging is
completed.(Fig 11)
Notes:
1.If the product is long idled after purchase, please use the adapter to charge the battery about every 3
months.
2.Do not leave the charger on power socket all the time to prevent children from touching it by mistake.
3.Keep the charger plug and your hands dry before inserting the charger into the charging stand,.
4.Before the first use, please fully charge the battery pack, and before the second charge, please empty the
battery to ensure the life of the battery pack.
6
clean water tank plug
clean water
tank handle
9
on/off button
mode button
10
11
water spray button