Jimmy HW9 Mode D'emploi page 12

Chapter 5 Troubleshooting
Please check the following points before contacting the after sale service.
Problem
Machine does not work
Weak suction
Weak suction
Abnormal noise
Floorhead does not
spray water
Water spray out from
air exhaust
Note: If the above troubleshooting guide fails to provide a solution,due to the need to use special tools,
please go to the designated maintenance station for repair and replacement or contact after service of local
distributor for support.
10
Possible cause
Low battery power
On/off button is not pressed down
Brushroll is entangled
Water in dirty water tank achieves
MAX line
On/off button or mode button is
pressed at the same time with water
spray button
Brushroll not assembled
Dirty water tank not assembled
Water in dirty water tank achieves
MAX line
Brushroll window and dirty water tank
not assembled properly
Brushroll entangled
Filter gets dirty
Lower battery power
Suction inlet blocked
Water in dirty water tank achieves MAX line
Clean water tank empty
Water spray button not pressed
Clean water tank not assembled
properly
Clean water tank is filled with dirty
water and blocked water path.
Excessive foaming of cleaning
solution
Water in dirty water tank achieves
MAX line
The product was heavily shaked or hits
the wall with big force
Filter is not assembled
Filter is put to use without fully dry
Solution
Recharge battery
Press down on/off button
Clean brushroll
Clean dirty water tank
Release water spray button, press
on/off button or mode button
separately
Reassemble brushroll
Reassemble dirty water tank
Clean dirty water tank
Reassemble brushroll window and
dirty water tank
Clean brushroll
Clean or replace filter
Recharge battery
Clean suction inlet
Clean dirty water tank
Fill clean water tank
Press water spray button
Reassemble clean water tank
Do not fill clean water tank with dirty
water
Add the cleaning solution in the
correct proportion
Take out the dirty water tank and
pour out the dirty water
Take out the dirty water tank and
pour out the dirty water
Assemble filter
Dry the filter after washing before
use