Jimmy HW9 Mode D'emploi page 6

Disassemble and assemble dirty water
tank
To take off dirty water tank, hold machine with one
hand and hold the dirty water tank with another hand,
press dirty water tank release button to remove dirty
water tank. To assemble dirty water tank, place dirty
water tank bottom into mainbody, push dirty water tank
towards mainbody until a "click" sound is heard.(Fig 6)
Disassemble and assemble clean
water tank
To take off clean water tank, hold the clean water tank
handle and pull out the clean water tank. To assemble
clean water tank, put the clean water tank back to
nozzle, align with the brushroll window. (Fig 7)
Disassemble and assemble brushroll
cover and brushroll
1.To take off brushroll cover hold brushroll cover
latch and pull upward to remove brushroll cover.
To assemble brushroll cover, align the clips on two
sides of brushroll cover with the slots on two sides of
floorhead. Press brushroll cover down until a "click"
sound is heard. (Fig 8)
2.To disassemble the brushroll, pull the brushroll cap outward to take out brushrol. To assemble the brushroll,
hold brushroll cap, slide brushroll over the cylinder until brushroll reaches the end. (Fig 8)
4
6
Clean water tank handle
7
pull the brushroll cover upward
latch
brushroll cap
8
Dirty water tank
release button
Dirty water tank
handle
Clean water tank