DirectHome MEDICAL Somnetics Transcend II Portable miniCPAP Guide Rapide page 7

CARING FOR YOUR TRANSCEND AND COMPONENTS
Dry Mode - Cleaning the Inside of Your Transcend
Dry Mode should be used daily to clean the inside of your Transcend.
Caution: Do not wear Transcend while it is in Dry Mode
1. Set the device on a dry and stable surface. A cloth surface is not recommended as it
may get soiled.
2. Plug the device into a power source.
3. To enable Dry Mode, press and hold the ramp button then press the power button.
4. Low pressure air flow will begin and last for 30 minutes until the cleaning sequence is
completed. The device will then return to Standby mode. To end the Dry Mode before
the 30 minute sequence is complete, press the power button. The device will return to
Standby mode.
Caution: Clean the inside of your Transcend with the Dry Mode only. Do not attempt to
use any other method to clean inside the Transcend device.
Cleaning the Transcend Exterior
1. Clean the exterior of your device as needed. To clean, wipe the surface with a lint-free
cloth or paper towel that has been dampened in water containing mild dishwashing
detergent. Following cleaning, wipe again after rinsing the cloth in clear water.
Caution: Never submerge Transcend in water. Do not allow soap or water to get into the
device.
Cleaning the Transcend Components
The interface should be washed weekly. The air supply tube should be washed daily.
1. Completely disconnect the components.
2. Hand wash in warm water with a mild dishwashing soap.
3. Rinse thoroughly.
4. Air dry; components must be completely dry before reconnecting.
5. Reconnect the components.
Do not put any of the Transcend components in the dishwasher or laundry
Caution:
machine.
TRANSCEND QUICK GUIDE • ENGLISH • PAGE 7