DirectHome MEDICAL Somnetics Transcend II Portable miniCPAP Guide Rapide page 6

STARTING AND ENDING THERAPY
Starting Therapy
1. The Transcend control
panel consists of a
power button
(bottom), ramp button
(top) and two LED
lights.
2. Ensure that the device
is connected to a
power source and is
in Standby mode. (See
Powering)
3. Press the lower, blue power button (
the blower delivers your prescribed pressure.
Using the Ramp Function
Ramp settings will be programmed by your provider if your prescription includes ramp.
1. Initiate ramp by pressing the ramp, or top, button after the power button has been
pressed.
Please note: the ramp button on Transcend will not work unless your prescription
includes ramp.
2. Therapy pressure will drop to a starting pressure that has been preset by your provider,
and will gradually increase over a preset period of time until it reaches your prescribed
therapy pressure.
3. To accelerate the ramp pressure, hold the ramp button down. The device will stop
ramp mode when it reaches your prescribed therapy pressure.
Ending Therapy
• To end therapy, press the blue power button to return the device to the Standby mode.
Green LED
) to turn on Transcend. Air flow will begin as
TRANSCEND QUICK GUIDE • ENGLISH
Ramp
Button
Power Button
• PAGE 6
Yellow LED