Setting Up Your E-Mu Pipeline - E-Mu CREATIVE PROFESSIONAL PIPEline Mode D'emploi

Setting Up Your E-MU PIPEline™

You may find it easier to configure and pair your E-MU PIPEline™ units at
one location before placing each unit at its final location.
NOTE
Flexi-Jacks will be either inputs or outputs depending on the
E-MU PIPEline™ transmit/receive mode setting. They can also be
either digital or analog depending on the mode setting.
Step 1: Configure your E-MU PIPEline™ units
Set the Mode DIP switches for your transmitter and receiver(s). Refer to the
following table for the appropriate settings. This table can also be found on
the bottom of your E-MU PIPEline™ unit.
For a transmitter-receiver group, set the settings for DIP switches CH, B/P
and D/A. Then set switch R/T to configure the unit as a transmitter or
receiver. A group consists of at least one transmitter and one receiver.
Position
+
0
-
For example, a transmitter to be used for broadcasting, using RF Channel 1,
streaming analog audio from an analog source should be set as follows:
CH B/P
Ch 1 Paired
Ch 2 -
Ch 3 Broadcast
Setting Up Your E-MU PIPEline™ 5
R/T
Transmit Analog without limiter
- Analog with limiter
Receive Digital (S/PDIF 48 kHz)
D/A