Using Your E-Mu Pipeline - E-Mu CREATIVE PROFESSIONAL PIPEline Mode D'emploi

Using Your E-MU PIPEline™

Adjusting volume
When E-MU PIPEline™ is configured as a transmitter, the volume buttons
on the transmitter function as attenuation buttons. To decrease the volume
of the audio being streamed to the receiver, press the "+" button to increase
attenuation and thus reducing the volume of the audio being streamed.
The volume buttons function as normal for E-MU PIPEline™ receivers.
Charging your E-MU PIPEline™
The E-MU PIPEline™ uses a 1200mAh Li-ion rechargeable battery. When
the battery power is low, the Power LED flashes red and white alternately.
When the battery is charging and the unit is not powered on, the Power LED
lights up red. When the battery is fully charged, the Power LED is not lit.
There is no "low-battery" indication when the external power supply
adapter is being used. A depleted battery takes up to three hours to become
fully charged. When fully charged, it can operate for approximately five to
eight hours without being connected to the power adapter.
Returning to factory default settings
To return E-MU PIPEline™ to factory default settings, press and hold the
Connect button on the rear of the unit for five seconds. The E-MU LED
flashes for two seconds before lighting up again.
Returning to factory default settings will do the following:
• Revert to the original volume setting,
• "Unpair" a receiver.
Using Your E-MU PIPEline™ 11