Troubleshooting Wireless Features - E-Mu CREATIVE PROFESSIONAL PIPEline Mode D'emploi

Troubleshooting Wireless Features

There is no sound from my receiver.
Check that:
• The signal source is working properly. If your transmitter is set to digital
mode, ensure that the source is set to stream 48 kHz S/PDIF.
• The transmitter is connected to the power outlet and turned on, or that it
is sufficiently charged (if you are not using an external power supply).
• The transmitter and receiver's Mode DIP switches are configured
correctly:
• Both are set to the same RF channel.
• Both are set to the identical mode, either Broadcast of Paired mode.
• Transmitter is set to transmit, and receiver set to receive.
• See "Configure your E-MU PIPEline™ units" on page 5.
• The receiver is connected to the power outlet and turned on, or that it is
sufficiently charged (if you are not using a power outlet).
• The Link LEDs are green, and your units are paired. See "The Link LEDs
do not light up." below.
• The receiver volume is not muted. Press the Power/Mute button.
• The receiver volume is turned up. Press the Volume Up button.
• The output system is turned on and working properly.
The Link LEDs do not light up.
This indicates that the signal from the transmitter is weak or the receiver
has lost its connection with the transmitter.
Try the following:
• Move your transmitter and receiver closer to each other.
Troubleshooting Wireless Features 13