Publicité
Les langues disponibles
Les langues disponibles
The air motor cannot be lubricated too often.
Disconnect the compressed air supply before lubrication
• Disconnect the device from the compressed air supply
• Turn the device upside down
• Press the tripping device when filling about 5 ml of oil into the compressed air inlet.
After having lubricated the compressed air device the lubricant will escape from the
sound absorber during the first few seconds. Therefore, it is necessary to cover the
sound absorber with a cloth, if compressed air is supplied to the device. If the sound
absorber is not covered it may result in injuries.
• Connect the device to the compressed air supply and cover the sound absorber with a cloth.
Let the device run for 20 to 30 seconds. Lubricant will escape from the sound absorber during
this process.
Troubleshooting
Error
Device does not
start or turns
slowly
Humidity escapes
Technical data:
*Drill adapter 8 mm
*idle-running speed 1.000 r/min
*Compressed air 6.3bar
*Air line 3/8" inner diameter
*Air connection 1/4"internal thread
Possible cause
Dirt in the device
No lubricant in the
device
Too little compressed
air
Compressed air hose
Pressure drop
Ball bearing soiled or
damaged
Water in the vessel
Water in the lines,
hoses
Solution
Rinse the device with special air oil (item No:
5354 100), solvent or a comparable mixture
of SAE 10 motor oil and diesel fuel. Lubricate
the device after cleaning.
Lubricate the device according to the de-
scription incl. in these instructions
Adjust the compressed air of the
compressor.
Repair leakages. damaged
Control the diameter and length of the air
hose. Hoses which are too large or too long
have a too high air volume which might cause
a pressure drop. A hose of an inner diameter
of 8 mm is perfect.
Disassemble the bearing, clean or replace it
Drain vessel (follow the instructions from the
device of the compressor). Start the device
until no more water is escaping. Lubricate the
device according to the lubricating instructions
Install a compressed air hoses maintenance
unit. Note: The filter only works, if com-
pressed air is cold Place the filter as far as
possible from the compressor
Install an air dryer
.
Publicité
