Klarstein DATSCHA DIGITAL Mode D'emploi page 21

7 DECREASE button: When setting temperature operation, corresponding (1°C)
followed by decreasing the temperature setting range 5°C - 45°C . When setting
a timer operation is to adjust the number of minutes, correspondence (1 minute) is
incremented, cyclic variations in the timing set within O to 59 minutes.
8 By holding either the INCREASE key or DECREASE key on the heater control panel.
you are able to fast scroll both temperature and timer digit selections. This option is
not available via the remote control!
9 INCREASE button and DECREASE keys support key combination operation,
namely three seconds while holding down two keys let go, you can enter the
ambient temperature inquiry, the display screen when the temperature value of the
current ambient temperature value, Show 4 seconds after the temperature of the
display screen returns the set temperature value.
10 Timer OFF: Set timing shutdown mode and an appointment time, this feature is only
effective in the operation of the heater, power shutdown is invalid.
1 1 Timer ON: Set regular boot mode and appointments, this feature is only valid when
heater in standby mode, operation invalid in boot state.
12 LOW key: Set the heat to manual mode, low power operation.
13 MID key: Set the heater to manual mode, the heater mid-power operation, the fan
runs at the same time.
14 HIGH key: Set the heater to manual mode, the heater high-end power operation,
the fan runs at the same time.
15 key: this key only available on remote controller, set the heater operating
power, operating low > mid > high power in order to cycle.
16 AUTO key: Set the heater to automatic operation mode.
17 DEFROST key: enable/disable the anti-frost function. Under frost mode, the set
temperature is fixed at 10°C, turn on the heating < 7°C ambient temperature, while
ambient temperature ~ 10°C turn off the heating.
18 ION key: Select On or Off the anion.
EN
21